Tub Reglazing Services in Hico, TX
Discover 1 professional tub reglazing business in Hico. Compare reviews, prices, and services.
Hico sits in Hamilton County in the rolling Cross Timbers region of Central Texas, roughly halfway between Stephenville and Comanche. It’s a small community, so your options for a local reglazier are limited. That makes it worth knowing what to ask before you book.
Most homes in this part of Texas were built in the mid-20th century, and cast iron tubs from that era are common. Those tubs are worth keeping. Cast iron holds heat well, the walls are thick enough to sand and recoat multiple times, and a good refinishing job on one of them can last 10 to 15 years with reasonable care.
Central Texas has hard, mineral-heavy water. It doesn’t affect the reglazing process directly, but it does mean the factory porcelain on older tubs often looks worse than it is underneath the calcium buildup. A pro will clean and acid-etch the surface before coating, and what looks like deep staining sometimes disappears at that stage. Ask the contractor whether they do an assessment before quoting, since the prep work on a heavily scaled tub takes more time.
One practical note for this part of the state: summer heat in a poorly ventilated bathroom can make the spray-applied coatings off-gas more aggressively. The isocyanate fumes from two-part urethane coatings are genuinely irritating to lungs and eyes. Make sure whoever you hire masks off the drain, tapes the room, and that you plan to stay out of the bathroom for at least 24 hours after the job.
Because there’s only one listing on this page, it may also be worth calling contractors in the Stephenville or Brownwood metro areas, both of which are within a reasonable service radius and tend to have more established tub refinishing operations.
Frequently Asked Questions
Is tub reglazing worth it in a small town like Hico where resale comps are modest?
Usually yes. Reglazing runs $300 to $600 in most of Texas, while tub replacement with tile surround work can easily hit $2,000 or more. In a modest market, spending less to restore a functional tub makes solid financial sense.
How does Central Texas heat affect a freshly reglazed tub?
High ambient temperatures speed up cure time, which is generally helpful, but a bathroom that gets very hot can cause the coating to cure unevenly if ventilation is poor. Keep a window cracked or run a fan during and after the job. Most coatings are fully cured within 24 to 48 hours in warm Texas conditions.
Will a reglazed tub hold up to hard water staining?
The coating itself resists staining better than worn porcelain, but Central Texas water is notoriously hard. Use a non-abrasive cleaner and wipe the tub dry after each use to extend the life of the finish.
Do I need a permit to have my tub reglazed in Texas?
No. Reglazing is a surface refinishing process, not a structural or plumbing alteration, so it doesn't trigger permit requirements under the Texas residential building codes.
